Full Freeview on the Oxford (Oxfordshire, England) transmitter
Google Streetview | Google map | Bing map | Google Earth | 51.790,-1.179 or 51°47'25"N 1°10'46"W | OX3 9SS |
The symbol shows the location of the Oxford (Oxfordshire, England) transmitter which serves 410,000 homes. The bright green areas shown where the signal from this transmitter is strong, dark green areas are poorer signals. Those parts shown in yellow may have interference on the same frequency from other masts.
This transmitter has no current reported problems
The BBC and Digital UK report there are no faults or engineering work on the Oxford (Oxfordshire, England) transmitter._______
Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which Freeview channels does the Oxford transmitter broadcast?
If you have any kind of Freeview fault, follow this Freeview reset procedure first.Digital television services are broadcast on a multiplexes (or Mux) where many stations occupy a single broadcast frequency, as shown below.
64QAM 8K 3/4 27.1Mb/s DVB-T MPEG2
DTG-12 QSPK 8K 3/4 8.0Mb/s DVB-T MPEG2
H/V: aerial position (horizontal or vertical)
Which BBC and ITV regional news can I watch from the Oxford transmitter?

BBC South (Oxford) Today 0.4m homes 1.6%
from Oxford OX2 7DW, 6km west-southwest (258°)
to BBC South (Oxford) region - 6 masts.
BBC South (Oxford) Today shares 50% content with Southampton service

ITV Meridian News 0.9m homes 3.4%
from Whiteley PO15 7AD, 102km south (183°)
to ITV Meridian/Central (Thames Valley) region - 15 masts.
Thames Valley opt-out from Meridian (South). All of lunch, weekend and 50% evening news is shared with all of Meridian+Oxford
How will the Oxford (Oxfordshire, England) transmission frequencies change over time?
1950s-80s | 1984-97 | 1997-98 | 1998-2011 | 2011-13 | 2013-18 | 2013-17 | 23 May 2018 | ||
VHF | C/D E | C/D E | C/D E | C/D E | C/D E T | W T | W T | ||
C2 | BBCtvwaves | ||||||||
C29 | SDN | ||||||||
C31 | com7 | com7 | |||||||
C37 | com8 | com8 | |||||||
C41 | BBCA | ||||||||
C44 | D3+4 | ||||||||
C46 | _local | ||||||||
C47 | BBCB | ||||||||
C49tv_off | C5waves | C5waves | |||||||
C50tv_off | SDN | SDN | |||||||
C51tv_off | LOX | LOX | |||||||
C53tv_off | C4waves | C4waves | C4waves | +BBCA | +BBCA | +BBCA | |||
C55tv_off | ArqB | ArqB | ArqB | com7tv_off | |||||
C56tv_off | COM8tv_off | ||||||||
C57tv_off | BBC1waves | BBC1waves | BBC1waves | BBCB | BBCB | BBCB | |||
C59tv_off | -ArqA | -ArqA | -ArqA | ||||||
C60tv_off | ITVwaves | ITVwaves | ITVwaves | -D3+4 | -D3+4 | -D3+4 | |||
C62 | SDN | ||||||||
C63 | BBC2waves | BBC2waves | BBC2waves |
tv_off Being removed from Freeview (for 5G use) after November 2020 / June 2022 - more
Table shows multiplexes names see this article;
green background for transmission frequencies
Notes: + and - denote 166kHz offset; aerial group are shown as A B C/D E K W T
waves denotes analogue; digital switchover was 14 Sep 11 and 28 Sep 11.
How do the old analogue and currrent digital signal levels compare?
Analogue 1-4 | 500kW | |
BBCA, D3+4, BBCB | (-7dB) 100kW | |
SDN, ARQA, ARQB | (-10dB) 50kW | |
Analogue 5 | (-11dB) 40kW | |
com8 | (-14.7dB) 17.1kW | |
com7 | (-14.8dB) 16.4kW | |
Mux 1*, Mux 2*, LOX | (-17dB) 10kW | |
Mux C*, Mux D* | (-18dB) 8kW | |
Mux A*, Mux B* | (-19.2dB) 6kW |
Local transmitter maps
Oxford Freeview Oxford DAB Oxford TV region BBC South (Oxford) Meridian/Central (Thames Valley micro region)Which companies have run the Channel 3 services in the Oxford transmitter area
|
|
Thursday, 30 January 2014
Caz: Your blond husband is switching off the booster which is likely to be located adjacent to the aerial. What is referred to as a "booster" is in fact a power supply for a booster which is fitted where the single feed from the aerial splits into two, one to each room. Thus, by turning off the power supply the booster has no power and a booster with no power will give out little or no signal.
link to this comment |
R
rob2:51 PM
Kidlington
Well, good news for you, mine is definitely interference from next door. Does anyone have any ideas on how i can protect against it?
Regards
Rob.
link to this comment |
M
mazbar3:03 PM
rob: I just have to ask have you had the aerial checked out. I have never heared of interfereance from the next house. If your coax is damaged this could be letting in the interfereance but a good aerial with good coax with sheliding should block it. So call someone out to check what the problem is this website is good for advice but without being at your house no one can give you 100% the answer.
link to this comment |
C
Chris8:39 PM
Rob: I'm in Oxfordshire and I had on and off reception with some channels last few weeks too and this week lost a lot of channels including the HD channels. Surely this is just down to the oxford transmitter engineering works this week? That would be why your neighbour also has poor reception. It was obviously not a great signal before which I assume is why they are working on it. Is there any way of finding out the details of the engineering work? (51.6887,-1.2717)
link to this comment |
MikeP
9:37 PM
Calne
9:37 PM
Calne
Caz
Because of Rob's very different location to you, the suggestion of a 'booster' (better called an aerial amplifier) is not correct. He is only 7 km away from the Oxford transmitter so gets a good strong signal already and it does not need amplifying. If it were then in his location he would have had far worse loss of services because of the signal then being far too strong.
As we do not have any idea of your location, other than it being in Buckinghamshire (with is not a small county), we cannot make any suggestions.
As David Linsay has stated, the item behind your TV set that is connected in the aerial feed cable is a power supply, the amplifier is mounted close to your aerial. The power supply needs to be left powered on to operate the aerial amplifier so your bedroom signals are properly delivered.
link to this comment |
MikeP
9:40 PM
Calne
9:40 PM
Calne
Mazbar
Much earlier in the discussion of Rob's problem it was established that it is only affecting one TV connected to his system in the room that is adjacent to the wall which has his neighbours Virgin equipment at the other side. The problem is not present on his other TV sets, so the aerial is fine and not a factor in this particular problem. Likewise, he has tried moving the TV set to the other side of the room successfully, again showing the aerial system is not a culprit.
link to this comment |
R
Rob10:55 PM
Thanks Mike P,
Hope the neighbors ring virgin for an engineer like they said they would. I cant see this being anything else than em interference, hoping that the engineer will move the offending source.
could by a new tv but don't really want too and there is no guarantee that the new one wont do the same.
regards
Rob
link to this comment |
Friday, 31 January 2014
J
jb3812:21 AM
Rob: Have you as yet tried turning your TV around by 90 degrees so as to have it facing end on to the offending wall? the reason for this request being that I suspect that your TV "might" be more susceptible to picking up locally generated EM interference directly into its PCB circuitry if any of the internal earth bonding jumpers used to link the metal screening cans on such as the tuners or any other vulnerable areas have not been tightened up properly, or indeed are missing! and should anything of that nature apply then any interference being picked up in that way is usually highly directional whereby is affected by angles, likewise turning the set around by 90 degrees or so being one way one way of revealing its existence without having the benefit of any test gear being to hand, that being your biggest impediment!
link to this comment |
M
mazbar6:09 AM
MikeP: that doesn't rule out any problem that having the system checked won't correct , but then again I don't know how to fix a tv I only know about aerials so I stick to advice about aerials.
link to this comment |
R
Rob6:30 AM
Hi jb38
yet to turn the tv around, i will have a go today if i get the chance, i thought that the shielding on the tv would have been good it being Sony. However this may be the first time it hAs been near any type of strong EMI so may have been faulty all along.
Is there any check i can do inside the TV?
cheers
Rob
link to this comment |
Select more comments
Your comment please